Ricoh M281 Series - Page 865

Error Codes
SM 31 D255/D256 FAX OPTION
D255/D256
FAX OPTION
Code Meaning Suggested Cause/Action
2-53
Snd msg() in the manual task
is an error because the
mailbox for the operation task
is full.
 The user did the same operation many
times, and this gave too much load to the
machine.
4-01 Line current was cut
 Check the line connector.
 Check for line problems.
 Replace the FCU.
4-10
Communication failed
because of an ID Code
mismatch (Closed Network) or
Tel. No./CSI mismatch
(Protection against Wrong
Connections)
 Get the ID Codes the same and/or the
CSIs programmed correctly, and then
resend.
 The machine at the other party may be
defective.
5-00
Data reconstruction not
possible
 Replace the FCU.
5-10 DCR timer expired  Replace the FCU.
5-20
Storage impossible because
of a lack of memory
 Temporary memory shortage.
 Test the SAF memory.
5-21 Memory overflow
5-23
Print data error when printing
a substitute RX or confidential
RX message
 Test the SAF memory.
 Ask the other party to resend the
message.
5-25 SAF file access error
 Replace an SD card or HDD.
 Replace the FCU.
6-00
G3 ECM - T1 time out during
reception of facsimile data
 Try adjusting the RX cable equalizer.
 Replace the FCU.
6-01
G3 ECM - no V.21 signal was
received
6-02 G3 ECM - EOR was received