Ricoh M281 Series - Page 866

Error Codes
D255/D256 FAX OPTION 32 SM
Code Meaning Suggested Cause/Action
6-04 G3 ECM - RTC not detected
 Check the connection.
 Check for a bad line or defective remote
terminal.
 Replace the FCU.
6-05
G3 ECM - facsimile data
frame not received within 18 s
of CFR, but there was no line
fail
 Check the connection.
 Check for a bad line or defective remote
terminal.
 Replace the FCU.
 Try adjusting the RX cable equalizer
Reference:
 RX cable equalizer - G3 Switch 07 (PSTN)
6-06
G3 ECM - coding/decoding
error
 Defective FCU.
 The other terminal may be defective.
6-08
G3 ECM - PIP/PIN received in
reply to PPS.NULL
 The other party pressed [Stop] during
communication.
 The other terminal may be defective.
6-09 G3 ECM - ERR received
 Check for a noisy line.
 Adjust the TX levels of the communicating
machines.
 See code 6-05.
6-10
G3 ECM - error frames still
received at the other party
after all communication
attempts at 2400 bps
 Check for line noise.
 Adjust the TX level (use NCU parameter
01 or the dedicated TX parameter for that
address).
 Check the connection.
 Defective remote terminal.
6-21
V.21 flag detected during high
speed modem communication
 The other terminal may be defective or
incompatible.
6-22
The machine resets the
sequence because of an
abnormal handshake in the
V.34 control channel
 Check for line noise.
 If the same error occurs frequently, replace
the FCU.
 Defective remote terminal.