NCU Parameters
D255/D256 FAX OPTION 126 SM
13 68054C Make time for pulse dialing
1 ms
See Note A.
SP2-103-014
14 68054D Time between final OHDI relay
closure and DO relay opening or
closing
1 ms
EU only.
SP2-103-015
See Notes A, D and
E.
15 68054E Minimum pause between dialed
digits (pulse dial mode)
20 ms
See Note A and E.
SP2-103-016
16 68054F Time waited when a pause is
entered at the operation panel
SP2-103-017
See Note A.
17 680550 DTMF tone on time 1 ms SP2-103-018
18 680551 DTMF tone off time SP2-103-019
19 680552 Tone attenuation level of DTMF
signals while dialing
-N x 0.5
–3.5 dBm
SP2-103-020
See Note C.
20 680553 Tone attenuation value difference
between high frequency tone and
low frequency tone in DTMF
signals -dBm x 0.5
SP2-103-021
The setting must be
less than –5dBm,
and should not
exceed the setting
at 680552h above.
See Note C.
21 680554 PSTN: DTMF tone attenuation
level after dialling
-N x 0.5
–3.5 dBm
SP2-103-022
See Note C.
22 680555 ISDN: DTMF tone attenuation level
after dialling
-dBm x 0.5
See Note C
A: Pulse dial parameters (addresses 68054A to 68054F) are the values for 10 pps. If 20
pps is used, the machine automatically compensates.
B: The first ring may not be detected until 1 to 2.5 wavelengths after the time specified by
this parameter.
C: The calculated level must be between 0 and 10.
The attenuation levels calculated from RAM data are:
High frequency tone:
To Next Page
Loading...
