Ricoh MET-C1 - Optional Counter Interface Unit Type a; Accessory Check; Installation Procedure; Key Counter

Optional Counter Interface Unit Type A
Accessory Check
No. Description Q’ty
- TAPPING SCREW:3X6 4
- WIRE BINDER 1
- 12.7MM:V-0 4
- CLAMP:LWS-0711Z 1
- HARNESS:IOB:MKB 1
Installation procedure
• When you install this option, switch the MFP’s power supply OFF, and unplug the power plug from
the mains outlet.
• If installed when the power is on, it will result in an electric shock or malfunction.
Key Counter
1. Rear right cover (page 231)
2. Installation
158