How to place MFP on the caster table
1. Attach the 3 locating pins.
2. Holding the grips on the machine, align with the locating pin, and place the machine on
the caster table.
• When you lift the machine, hold the lifting handles.
• In particular, do not lift it by holding the scanner unit, etc., (as it may deform). .
• Do not put the machine down on the caster table as a temporary resting place. This may
cause the machine to deform. Always connect the machine and caster unit properly.
3. Pull out the 2nd paper feed tray.
4. Using a securing bracket, fix the machine to the paper tray unit (spring washer : screw:
M4×10: 1).
5. Attach the securing brackets [A] at 2 positions to left and right at the rear of the machine
(screws: 1 each).
6. Return the paper feed tray to the machine.
How to place the Paper Feed Unit PB3150 on the caster table
1. Attach the 3 locating pins.
2. Place the paper feed unit on the caster table.
3. Pull out the 1st paper feed tray of the paper feed unit.
4. Using a securing bracket, fix the caster table to the paper tray unit (spring washer : screw:
M4×10: 1).
5. Attach the securing brackets at 2 positions to left and right at the rear of the machine
(screws: 1 each).
2. Installation
80
To Next Page
Loading...
