Main Machine Installation
Important notice on security issues
In order to increase the security of the MFP, and to ensure that the customer sets the administrator
password, an administrator set/change prompt display is shown up at the first power-up.
Overview
• The following Program/Change Administrator screen is displayed at the first power-up.
• When the customers set the administrator/supervisor login password, the display disappears and
the home display will appear. The customers, however, can erase this screen with the following
procedure in the case that they think there is no need to set the password.
1. On the Program/Change Administrator screen, press [Change] next to Supervisor and
then touch [OK] without inputting any password.
2. Touch [OK] again when the Confirm password display shows up.
3. For Administrator 1, do the same procedure as steps 1 and 2.
4. Press the [OK] button, then the home display appears.
• SP5-755-002 allows you to skip this screen temporarily and continue the installation procedure
without setting an administrator password. However, the Program/Change Administrator screen
appears every time you turn the power OFF/ON, if the password is not set.
Main Machine Installation
53
To Next Page
Loading...
