SC No. Level Error Name/Error Condition/Major Cause/Solution
-02 D Lamp Error (LED illumination adjustment)
LED error was detected.
• LED defective
• IDB (LED driver) defective
• Power/signal harness defective
1. Turn the power off/on.
2. Perform the following operations:
• Reconnect the power/signal harness.
3. Replace the following parts:
• Replace the LED board.
• Replace the IDB board or SIO board.
• Replace the power/signal harness.
SC No. Level Error Name/Error Condition/Major Cause/Solution
SC102-00 D LED Illumination Adjustment Error
The white level peak reached the prescribed threshold when the white
plate was scanned after a specified number of adjustments.
• LED defective
• IDB (LED driver) defective
• SBU defective
• IPU defective
• Power/signal harness defective
1. Turn the power off/on.
2. Reconnect the power/signal harness.
3. Replace the following parts:
• Replace the LED board.
• Replace the SBU board.
• Replace the IDB board or SIO board.
• Replace the IPU board.
• Replace the power/signal harness.
Service Call 101-195
451
To Next Page
Loading...
