SC No. Level Error Name/Error Condition/Major Cause/Solution
SC503-32 B
3rd Tray Lowering Error (LCIT)
• Lower limit detection error (during descent)
During tray initialization (upper limit not detected/lower eject limit
detection), the tray base plate is lowered to check the tray base plate
position, and the lower limit sensor is not detected although a
predetermined time elapsed.
Alternatively, at paper end, the tray base plate is lowered, but the lower
limit sensor is not detected although a predetermined time elapsed.
• Lower limit error (during ascent)
During tray initialization (upper limit eject detection/lower limit
detection), the tray base plate is raised to check the tray base plate
position, and the lower limit sensor is detected although a predetermined
time elapsed.
*If an error occurs 3 times consecutively: LCIT transmits "3rd tray lower
limit detection error" to the main machine. Up to 2 times consecutively,
LCIT transmits "tray set fault" to the main machine.
5. Troubleshooting
484
To Next Page
Loading...
