EasyManua.ls Logo

Ricoh MET-C1 - Page 501

Ricoh MET-C1
688 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SC No. Level Error Name/Error Condition/Major Cause/Solution
SC522-00 C Paper Exit Motor: Lock
During motor ON, after checking the motor error notification registers
(err_velo and err_posi) for 500msec, the error state of either register was
detected at least 5 times.
Motor defective
Connector disconnected
Harness broken
IOB defective
Encoder defective
Replace the motor
Reset the connector
Replace the harness
Replace the IOB
SC No. Level Error Name/Error Condition/Major Cause/Solution
SC530-00 D Fusing Exhaust Heat Fan Lock
In the motor ON state, the value of the lock sensor is checked every
100msec.
If a lock signal is not obtained for 50 times consecutively.
Motor defective
Connector disconnected
Harness broken
IOB defective
Replace the fusing exhaust heat fan
Reset the connector
Replace the harness
Replace the IOB
SC No. Level Error Name/Error Condition/Major Cause/Solution
SC531-01 D Development Intake Fan/Right Lock
Service Call 501-584
499

Table of Contents

Related product manuals