3. Holding the grips on the machine, align it with the locating pin [A], and place the machine
on the paper feed unit.
• When you lift the machine, hold the correct locations.
• In particular, do not lift the machine by holding the scanner unit, etc., because this may cause
the machine to deform.
• Do not put the machine down on the paper feed unit as a temporary resting place. This may
cause the paper feed unit to deform. Always connect the machine and paper feed unit
properly.
4. Pull out the 2nd paper feed tray.
5. Using a securing bracket as a screwdriver, fix the machine to the feed unit (spring
washer: screw: M4×10: 1).
2. Installation
76
To Next Page
Loading...
