Ricoh MET-C1 - Page 88

2. Insert the two stud screws ([A] is the larger stud, [B] is the smaller stud).
3. Mount the ARDF [A] by aligning the screw keyholes [B] of the ARDF support plate over
the stud screws.
4. Slide the ARDF toward the front of the machine.
5. Secure the ARDF with the two knob screws [C].
6. Align the rear left corner of the platen sheet [A] with the corner [B] on the exposure glass.
7. Close the ARDF.
2. Installation
86