Remote Maintenance by telnet
63
2
❖ IP TTL setting
msh> bonjour ip ttl {1-255}
You can specify the IP TTL (the
number of routers a packet can
pass through).
Note
❒ The default is 255.
❖ Resetting the computer name and lo-
cation information
You can reset the computer name
and location information.
msh> bonjour clear {cname
| location}
•cname
Reset the computer name. The
default computer name will be
displayed when the computer is
restarted.
•location
Reset the location information.
The previous location informa-
tion will be deleted.
❖ Interface configuration
msh> bonjour linklocal
“interface_name”
• If many types of interface are in-
stalled, configure the interface
that communicates with linklo-
cal address.
• If you do not specify an inter-
face, the Ethernet interface is
automatically selected.
• ip1394 can be specified only when
the IEEE 1394 interface is installed.
• wlan can be specified only when the
IEEE 802.11b interface is installed.
btconfig
Use the "btconfig" command to make
Bluetooth settings.
❖ View settings
Bluetooth settings are displayed.
msh> btconfig
❖ Mode settings
You can set the Bluetooth opera-
tion mode to {private} or {public}.
msh> btconfig {private |
public}
• The default is {public}.
devicename
Use the "devicename" command to
display and change the printer name.
❖ View settings
msh> devicename
❖ Printer name configuration
msh> devicename name
“string”
• Enter a printer name using up
to 31 alphanumeric characters.
• Set single names for each print-
er.
❖ Printer name initialization
msh> devicename clear name
• Reset the printer name to its de-
fault.
Interface Interface config-
ured
ether Ethernet interface
ip1394 IEEE 1394 interface
wlan IEEE 802.11b inter-
face
To Next Page
Loading...
Need help?
General
