Ricoh Printer/Scanner Unit Type 8000 Network Guide

Remote Maintenance by telnet
75
2
snmp
Use the “snmp” command to display
and edit SNMP configuration settings
such as the community name.
❖ View settings
msh> snmp
• Default access settings 1 is as
follows:
Community name:public
IPv4 address:0.0.0.0
IPv6 address:::
IPX ad-
dress:00000000:000000000000
Access type:read-only
Effective Proto-
col:IPv4/IPv6/IPX
• Default access settings 2 is as
follows:
Community name:admin
IPv4 address:0.0.0.0
IPv6 address:::
IPX ad-
dress:00000000:000000000000
Access type:read-write
Effective Proto-
col:IPv4/IPv6/IPX
• If "-p" is added, you can view
settings one by one.
• To display the current commu-
nity, specify its registration
number.
❖ Display
msh> snmp ?
❖ Community name configuration
msh> snmp “number” name
“community_name”
• You can configure ten SNMP
access settings numbered 1-10.
• The printer cannot be accessed
from SmartDeviceMonitor for
Admin or SmartDeviceMonitor
for Client if “public” is not reg-
istered in numbers 1-10. When
changing the community name,
use SmartDeviceMonitor for
Admin and SNMP Setup Tool
to correspond with printer set-
tings.
• The community name can be
entered using up to 15 charac-
ters.
❖ Deleting community name
msh> snmp “number” clear name
❖ Access type configuration
msh> snmp “number” type
“access_type”
Access type Type of access per-
mission
no not accessible
read read only
write read and write
trap user is notified of
trapmessages

Ricoh Printer/Scanner Unit Type 8000 Specifications

General

Brand	Ricoh
Model	Printer/Scanner Unit Type 8000
Category	All in One Printer
Language	English