Ricoh Printer/Scanner Unit Type 8000 Network Guide

Remote Maintenance by telnet
77
2
❖ SNMP v3 TRAP configuration display
msh> snmp v3trap
msh> snmp v3trap {1-5}
• If a number from 1-5 is entered,
settings are displayed for that
number only.
❖ Configuring a sending address for
SNMP v3 TRAP
msh> snmp v3trap {1-5}
{ipv4|ipv6|ipx} “address”
❖ Configuring a sending protocol for
SNMP v3 TRAP
msh> snmp v3trap {1-5} ac-
tive {ipv4|ipv6|ipx}
{on|off}
❖ Configuring a user account for SNMP
v3 TRAP
msh> snmp v3trap {1-5} ac-
count “account_name”
• Enter an account name using up
to 32 alphanumeric characters.
❖ Deleting an SNMP v3 TRAP user ac-
count
msh> snmp v3trap {1-5}
clear account
❖ Configuring an SNMP v3 encryption
algorithm
msh> snmp v3auth {md5|sha1}
❖ Configuring SNMP v3 encryption
msh> snmp v3priv {auto|on}
• Set "auto" for automatic encryp-
tion configuration
•Set "on" for mandatory encryp-
tion configuration.
sntp
The printer clock can be synchronized
with a NTP server clock using Simple
Network Time Protocol (SNTP). Use
the "sntp" command to change SNTP
settings.
❖ View settings
msh> sntp
❖ NTP server address configuration
You can specify the IP address of
the NTP server.
msh> sntp server “IP_address”
❖ Interval configuration
msh> sntp interval “polling
_time”
• You can specify the interval at
which the printer synchronizes
with the operator-specified
NTP server. The default is 60
minutes.
• The interval can be entered
from 0, or between 16 and
10,080 minutes.
• If you set 0, the printer synchro-
nizes with the NTP server only
when you turn the printer on. Af-
ter that, the printer does not syn-
chronize with the NTP server.
❖ Time-zone configuration
msh> sntp timezone “+/-
hour_time”
• You can specify the time differ-
ence between the printer clock
and NTP server clock. The val-
ues are between –12:00 and
+13:00.

Ricoh Printer/Scanner Unit Type 8000 Specifications

General

Brand	Ricoh
Model	Printer/Scanner Unit Type 8000
Category	All in One Printer
Language	English