Ricoh Printer/Scanner Unit Type 8000 Network Guide

Monitoring and Configuring the Printer
76
2
❖ Protocol configuration
msh> snmp {ipv4|ipv6|ipx}
{on|off}
• Use the following command to
set protocols "active" or "inac-
tive": If you set a protocol "inac-
tive", all access settings for that
protocol are disabled.
• Specify "ipv4" for IPv4, "ipv6"
for IPv6, or "ipx" for IPX/SPX.
• {on} means "active" and {off}
means "inactive".
• Only IPv4 supports the IEEE
1394 interface.
• All protocols cannot be turned
off concurrently.
❖ Configuration of protocol for each
registration number
msh> snmp “number” active
{ipv4|ipv6|ipx} {on|off}
• To change the protocol of access
settings, use the following com-
mand. However, if you have
disabled a protocol with the
above command, activating it
here has no effect.
❖ Access configuration
msh> snmp “number” {ipv4|
ipv6|ipx} “address”
• You can configure a host ad-
dress according to the protocol
used.
• The network interface board ac-
cepts requests only from hosts
that have IPv4, IPv6, and IPX
addresses with access types of
"read-only" or "read-write". En-
ter “0” to have network inter-
face board accept requests from
any host without requiring a
specific type of access.
• Enter a host address to deliver
"trap" access type information to.
• To specify IPv4 or IPv6, enter
"ipv4" or "ipv6" followed by a
space, and then the IPv4 or IPv6
address.
• To specify IPX/SPX, enter "ipx"
followed by a space, the IPX ad-
dress followed by a decimal,
and then the MAC address of
the network interface board.
❖ sysLocation configuration
msh> snmp location
❖ Deleting sysLocation
msh> snmp clear location
❖ sysContact setting
msh> snmp contact
❖ Deleting sysContact
msh> snmp clear contact
❖ SNMP v1v2 function configuration
msh> snmp v1v2 {on|off}
• Specify "on" to enable, and "off"
to disable.
❖ SNMP v3 function configuration
msh> snmp v3 {on|off}
• Specify "on" to enable, and "off"
to disable.
❖ SNMP TRAP configuration
msh> snmp trap {v1|v2|v3}
{on|off}
• Specify "on" to enable, and "off"
to disable.
❖ Remote Configuration Authorization
configuration
msh> snmp remote {on|off}
• Specify "on" to enable, and "off"
to disable the SNMP v1v2 setting.

Ricoh Printer/Scanner Unit Type 8000 Specifications

General

Brand	Ricoh
Model	Printer/Scanner Unit Type 8000
Category	All in One Printer
Language	English