Remote Maintenance by telnet
65
2
diprint
The direct printing port enables direct
printing from a network-connected
computer.
Use the “diprint” command to
change direct printing port settings.
❖ View settings
The following command displays the
current direct printing port settings:
msh> diprint
Example output:
port 9100
timeout=300(sec)
bidirect on
con multi
apl async
• The “port” specifies the port
number of the direct printing
port.
• The “bidirect” setting indicates
whether the direct printing port
is bidirectional or not.
❖ Setting timeout
msh> diprint timeout [30~
65535]
• You can specify the timeout in-
terval to use when the printer is
expecting data from the net-
work.
• The default is 300 seconds.
❖ Specifying the number of concurrent
connections
msh> diprint con {multi |
single}
• The above command specifies
the number of concurrent
diprint connections. Specify
“multi” for multiple connec-
tions or “single” for a single
connection.
• The default is “multi”.
dns
Use the “dns” command to configure
or display DNS (Domain Name Sys-
tem) settings.
❖ View settings
The following command displays
current DNS settings:
msh> dns
❖ IPv4 DNS server configuration
The following command enables
or disables the IPv4 DNS server
address:
msh> dns “number” server
“server address”
The following command displays
a configuration using the IP ad-
dress 192.168.15.16 on a DNS 1
server:
msh> dns 1 server 192.168.
15.16
• You can register IPv4 DNS Serv-
er address.
• You can register up to three
IPv4 DNS server numbers.
• You cannot use “255.255.255.255”
as the DNS server address.
❖ IPv6 DNS server configuration
The following command enables
or disables the IPv4 DNS server
address:
msh> dns “number” server6
“server address”
• You can register IPv6 DNS Serv-
er address.
• You can register up to three
IPv6 DNS server numbers.
To Next Page
Loading...
Need help?
General
