Monitoring and Configuring the Printer
74
2
show
Use the "show" command to display
network interface board configura-
tion settings.
❖ View settings
msh> show
• If "-p" is added, you can view
settings one by one.
Reference
p.98 “Configuring the Network In-
terface Board”
slp
Use “slp” command to view and con-
figure SLP settings.
msh> slp ttl “ttl_val”
• You can search the NetWare server
using SLP in the PureIP environ-
ment of NetWare 5/5.1. Using the
"slp" command, you can configure
the value of TTL which can be used
by SLP multicast packet.
• The default value of TTL is 1. A
search is executed only within a lo-
cal segment. If the router does not
support multicast, the settings are
not available even if the TTL value
is increased.
• The acceptable TTL value is be-
tween 1 and 255.
smb
Use the “smb” command to configure
or delete the computer or workgroup
name for SMB.
❖ Computer Name settings
msh> smb comp “computer
name”
• Set computer name using up to
15 characters. Names beginning
with "RNP" or "rnp" cannot be
entered.
❖ Working Group Name settings
msh> smb group “work group
name”
• Set workgroup name using up
to 15 characters
❖ Comment settings
msh> smb comment “comment”
• Set comment using up to 31
characters.
❖ Notify print job completion
msh> smb notif {on | off}
• To notify print job completion,
specify “on”. Otherwise, specify
“off”
❖ Deleting Computer Name
msh> smb clear comp
❖ Deleting Group Name
msh> smb clear group
❖ Deleting Comment
msh> smb clear comment
❖ View Protocol
msh> smb protocol
To Next Page
Loading...
Need help?
General
