Monitoring and Configuring the Printer
72
2
❖ Setting IPv6 Default Gateway
msh> route add6 default
gateway
❖ Adding a specified IPv6 destination to
Routing Table
msh> route add6 {destina-
tion} prefixlen gateway
•Specify the IPv6 address to des-
tination and gateway.
❖ Deleting a specified IPv6 destination
from Routing Table
msh> route delete6 {desti-
nation} prefixlen
•Specify the IPv6 address to des-
tination and gateway.
❖ Display information about a specified
IPv6 route information
msh> route get6 {destina-
tion}
•Specify the IPv6 address to des-
tination and gateway.
❖ Enabling/disabling a specified IPv6
destination
msh> route active6 {desti-
nation} prefixlen {on |
off}
❖ Route initialization
msh> route flush
Note
❒ The maximum number of IPv4
routing tables is 16.
❒ The maximum number of IPv6
routing tables is 2.
❒ Set a gateway address when com-
municating with devices on an ex-
ternal network.
❒ The same gateway address is
shared by all interfaces.
❒ “Prefixlen” is a number between 1
and 128.
set
Use the "set" command to set the pro-
tocol information display "active" or
"inactive".
❖ View settings
The following command displays
protocol information (active/inac-
tive).
msh> set ipv4
msh> set ipv6
msh> set appletalk
msh> set netware
msh> set smb
msh> set scsiprint
• scsiprint is available when the
optional IEEE 1394 interface
board is installed.
msh> set ip1394
• ip1394 is available when the op-
tional IEEE 1394 interface board
is installed.
msh> set protocol
• When protocol is specified, in-
formation about TCP/IP, Ap-
pleTalk, Netware, SCSI print,
IPv4 over 1394, PictBridge and
SMB appears.
msh> set lpr
msh> set lpr6
msh> set ftp
msh> set ftp6
msh> set rsh
msh> set rsh6
msh> set diprint
msh> set diprint6
msh> set web
msh> set snmp
msh> set ssl
msh> set ssl6
To Next Page
Loading...
Need help?
General
