Ricoh Printer/Scanner Unit Type 8000 Network Guide

Monitoring and Configuring the Printer
78
2
spoolsw
Use the “spoolsw” command to view
and configure Job Spool settings.
You can only specify diprint, trap, lpr,
ipp, ftp, sftp, and smb(TCP/IP) pro-
tocol.
• The “spoolsw” command for con-
figuring Job Spool settings is avail-
able only when the optional hard
disk is installed.
❖ View settings
The Job Spool setting appears.
msh> spoolsw
❖ Job Spool setting
msh> spoolsw spool {on|off}
Note
❒ Specify "on" to enable Job Spool,
or "off" to disable it.
❖ Resetting Job spool setting
msh> spoolsw clear job
{on|off}
• When the printer power is cut
during job spooling, this deter-
mines whether to reprint the
spooled job.
❖ Protocol configuration
msh> spoolsw diprint
{on|off}
msh> spoolsw lpr {on|off}
msh> spoolsw ipp {on|off}
msh> spoolsw smb {on|off}
msh> spoolsw ftp {on|off}
msh> spoolsw sftp {on|off}
• You can specify the settings for
diprint, lpr, ipp, ftp, sftp, and
smb.
sprint
Use the “sprint” command to view
and configure IEEE 1394 (SCSI print)
settings.
❖ View settings
IEEE 1394 (SCSI print) settings are
displayed.
msh> sprint
❖ Bidirectional configuration for IEEE
1394 (SCSI print)
Use this setting to set IEEE 1394
(SCSI print) bidirectional.
The default is “on”.
msh> sprint bidi {on | off}
ssdp
Use the “ssdp” command to view and
configure SSDP settings.
❖ View settings
msh> ssdp
❖ Setting effective time
msh> ssdp profile {1801–
86400}
The default is 10800 seconds.
❖ Advertise packet TTL settings
msh> ssdp ttl {1–255}
The default is 4.

Ricoh Printer/Scanner Unit Type 8000 Specifications

General

Brand	Ricoh
Model	Printer/Scanner Unit Type 8000
Category	All in One Printer
Language	English