3.2 SHORT INSTRUCTION GUIDE
RIELE BERLIN Photometer 5010 Service 3.2.1 22.08.2003
MODE FUNCTIONS
The mode functions serve for changing definite basic settings during a course of method. It is not necessary to
exit the method and to change to the level of UTILITY PROGRAMS (OM chapter 8). Also temporary parameters
remain unchanged. Corresponding to these features this group of functions is available only within the repetition
sequence of a course of method (chapter 5.5 – DESCRIPTION OF METHOD COURSES).
Change to the selection level of the mode functions with [MODE].
Selection level of the mode functions:
Selecting the desired mode function by
direct selection i.e. input of the number key in question (see table) or by scrolling
through all mode functions with [+] ... [+]. Confirm with [ENTER].
Exit the selection level of the mode functions and change back to the course of
method with [BREAK].
After working off a mode function the return is carried out to the course of method.
MODE FUNCTIONS
Key/-combination
Function Chapter
[MODE] [4]
Parallel printers ON / OFF 5.6
[MODE] [5]
Multi-standard tools 5.10
[MODE] [6]
Pump utilities 5.7
[MODE] [7]
Serial interface utilities 5.8
[MODE] [8]
Changing sample numerator 5.9
MODE FUNCTIONS
To Next Page
Loading...
