6.3 DOS: DOWNLOAD TO FLASH MEMORY
RIELE BERLIN Photometer 5010 / V4 6.7 25.08.2003
FLASH Memory
The FLASH memory IC14 (28F512) is a non-volatile memory which may be erased and programmed
electrically. This feature allows to replace the software of Photometer 5010 consisting of:
• operating system
• method data
• text data
The process is done by a serial interface utility DOWNLOAD ( see OM chapter 5.8) and a software modul
running on a personal computer. The devices Photometer 5010 and the personal computer have to be
connected by a serial interface cable.
1. Connect the devices Photometer 5010 and the personal computer by a serial interface cable.
2. Switch on both devices.
3. Install in a new directory of the personal computer the files DL_5010.EXE, D_LOAD.HEX and
P_100.HEX.
4. Photometer 5010: Start the serial interface utility DOWNLOAD ( see OM chapter 5.8) by [MODE]
[SERIAL] [5] [ENTER].
5. Personal computer: Change to DOS-input level. Select the directory with the installed three files.
Start the program file DL_5010.EXE.
DL_5010.EXE is a stand alone executable file for IBM/DOS systems.
6. The menu shows following items:
0 -> END of application
1 -> Select port COM 1
2 -> Select port COM 2
3 -> DOWNLOAD to Photometer 5010
4 -> RESUME after malfunction
7. By item 1 or item 2 the port of the serial interface can be selected. After starting the program the
default value is COM 1.
8. By item 3 the DOWNLOAD to Photometer 5010 is startet.
A progress bar shows the transferring of the files D_LOAD.HEX and P_100.HEX to Photometer
5010. The operation needs a time of approximate three minutes.
IMPORTANT:
Be sure that during this operation there is no power fail. Do not interrupt the running
program.
9. After end of operation Photometer 5010 performs a restart operation and shows the start menue.
Otherwise in case of malfunction:
10. The Photometer 5010 shows a dialog after finishing the DOWNLOAD to Photometer 5010 and after
waiting more than five minutes:
11. Switch off Photometer 5010.
12. Turn device on its top side.
13. Dismantle lid of FLASH MEMORY or EPROM (see drawing in SERVICE MANUAL
chapter 6.2).
DOWNLOAD Vx.x
PLEASE WAIT
To Next Page
Loading...
