‐55‐
C
OMMANDS
ACCESS TO THE COMMAND PANEL
The “Power User” access level is required for accessing the Command Panel.
From this page it is possible to activate switch on/off commands for the system or for the individual module.
It is also possible to perform a battery test or force system operation from a static bypass.
Operate the sliding switch to execute a command. The progress bar shows the progress of the start-up/shut-down sequence.
SYSTEM OFF/ON COMMAND
Operate the sliding switch from O to I to switch the system on.
A confirmation of the action is requested for some of the commands.
To Next Page
Loading...
Need help?
General
