Replacing and Disposing Consumables
Replacing the Master Roll
90
Tip:
• If you cannot insert the leading edge of the
master well, use the following procedure:
1) Raise the Master Guide Flap.
Turn the wheel beside the Master Guide Flap
inward to raise the Master Guide Flap.
2) Pull out the Master Roll up to the line
indicated by the arrows.
3) Lower the Master Guide Flap to the
original position.
10 Return the units to the original posi-
tions.
Close the Master Making Unit Cover, return the
Master Making Unit to the original position, and
then close the Front Cover.
To Next Page
Loading...
