Customizing the Initial Settings
INITIAL SETTINGS OPEN TO ARBITRARY CHANGES
Title
Image Processing
Print Speed
Print Density
Scanning Contrast
Auto Process
Book Size (Wide)
Book Size (Long)
Book Erasure Width
Multi-Up Interval
Energy Saving Mode
Description
Selects the initial image processing
mode.
Selects the initial print speed (copies per
minute).
Selects the initial print density.
Selects the initial setting of the Original
scanning contrast.
Selects the initial status of the Auto
Process feature.
Selects the initial opened book size to be
specified for the book placed wide on the
Stage glass.
Selects the initial opened book size to be
specified for the book placed longways
on the Stage glass.
Specifies the initial erasure width of the
book spine shadow applied in the Bound
Original processing feature.
Selects if an interval is required or not,
for replacing the original placed on the
Stage glass for Multi-Up printing.
Selects if energy is required to be saved
or not, while your RISOGRAPH is idle.
Two modes, "Auto Power-off" and "Auto
Sleep", are available to save energy.
If "Auto Power-off" is selected, the power
will be turned off automatically when your
RISOGRAPH remains idle for a specified
period.
If "Auto Sleep" is selected, on the other
hand, the power supply will be shut off
only for the control panel under the same
condition, thus allowing your
RISOGRAPH to receive PC data even in
the energy saving mode.
You can specify the idle period
required to lead your
RISOGRAPH into the energy
saving mode, using the Energy
save timer.
☞ See the next page.
Choices
Line, Duo, Photo
Level 1(=60),
Level 2(=80),
Level 3(=100),
Level 4(=120),
Level 5(=130)[cpm]
Light, Medium light,
Standard, Medium
dark, Dark
Auto, Light, Medium
light, Standard, Medium
dark, Dark
ON, OFF
RN2050/2150 : A3, B4,
A4, B5, A5, Foolscap
RN2000/2030/2130 :
Ledger,
Legal, Letter,
Statement
RN2050/2150 : A4, B5,
A5
RN2000/2030/2130 :
Letter, Statement
RN2050/2150 : 10 mm
RN2000/2030/2130 :
0.5inch
None(No interval),
15 Seconds
Auto Power-OFF, Auto
Sleep, OFF
The "Auto Sleep" mode
is available as standard
only for the RN21
series models.
For the RN20 series
models, the optional
Printer Control Board
RISORINC2 is required
to use the "Auto Sleep"
mode.
Ref.Page
p.30
p.40
p.41
p.36
p.32
p.38
p.38
p.38
p.46
p.26, 82
* The framed item is the default setting.
NOTE
72
NOTE
69
Automatic
Idle
The Automatic Idle feature assures consistent print quality
even after a long break by rotating the Print Cylinder
(Drum) to ensure even ink distribution, and saves you from
wasting paper due to faint images in printing.
When ordinary or test printing takes place after a
long break, the Automatic Idle feature is ignored
even when the Automatic Idle indicator is lit.
Whenever the Automatic Idle indicator is lit, the Automatic
Idle feature is on. If you want to use this feature when the
indicator is not lit, press the AUTO IDLE key to activate it.
This feature is automatically activated if the power is
switched on when the machine has not been used for a
certain period (6 to 12 hours).
You can select the minimum period required for
the automatic activation of the Automatic Idle
feature.
☞ p.70......You can customize initial settings.
To Next Page
Loading...
