SPIROR HP - DR
3.2. DESCRIPTION OF THE
OPERATION CYCLE
Wrapping cycles performable
Product wrapping can be:
1) "Total" wrapping
The product is completely spiral wrapped
with a series of extra revolutions on head
and tail.
2) "Head - tail" wrapping
the product is only wrapped on head and
tail.
3) "Complete" wrapping and "central bands"
The product is completely wrapped in a spiral, with a series of additional loops at the head, at the tail
and with a series of reinforcement strappings spaced by a programmable time.
4) "Head-tail" and "central belts" wrapping
The product head and tail are wrapped with a series of reinforcing bands spaced by a programmable
time.
5) “Head and additional bands” winding
The head of the product is wrapped and a series of additional reinforcement strappings are made (their
number and the distance between them can be set from the relevant parameters).
6) "By-pass" cycle
the product goes through the machine without being wrapped.
English
To Next Page
Loading...
