SPIROR HP - DR
2. SAFETY INFORMATION
2.1. GENERAL SAFETY PRECAUTIONS
Carefully read the “Directions for use”, paying particular attention to the “Residual risks”.
Pay attention to the safety warnings.
Use the machine only for the use for which it is designed.
Sometimes, accidents can be caused by a "careless" use of the machine by the operator.
Pay maximum attention.
Preserve the readability of the information signs and observe the indications given.
Do not tamper with the safety devices and protections.
The personnel authorised to carry out any operation on the machine has to be adequately trained.
2.1.1.EMPLOYER OBLIGATIONS
The operator must possess the required training and meet the suitable conditions for carrying out the
activities in safety conditions.
The employer must inform the operator on the INCORRECT USES predictable and on the persistent
Residual risks.
The operator must be capable of reading and understanding the user manual and must easily identify
the safety signs.
The employer must adequately document the training obtained by the operators.
2.2. SAFETY WARNINGS FOR HANDLING AND INSTALLATION
The personnel authorised to handle the machine (loading and unloading) must possess particular
expertise in the field of intervention.
Carry out handling (loading and discharge) according to the information delivered together with the
product.
During handling use one or two assistants, if required. This operation may generate unpredictable risks.
In order to minimise the risks related to assistants' involvement, you must inform them priorily on the
type of work and the behaviour to be used.
The machine must be handled with the aid of specific means (crane, forklift etc.) by qualified personnel
capable of observing the safety requirements.
When using the lifting means, insert and/or fasten the devices (hooks, forks etc.) ONLY into the points
provided on the package and/or the machine.
Transport the machine suitable means of adequate capacity.
The minimum and maximum temperature (during transport and/or storage) must fall within the range
allowed in order to prevent damaging the electrical components.
Install the machine ONLY in spaces free of explosion and /or fire risks.
Avoid the spaces exposed to atmospheric and corrosive agents.
Assess, prior to installation, if it is necessary to draw up a "safety plan" in order to protect the safety of
the personnel involved.
Ensure suitable safety conditions for carrying out works at height in areas difficult to reach or however
dangerous.
Install the machine according to the minimum perimeter indicated by the manufacturer and the
surrounding activities.
Should the machine interface directly/indirectly with other machines or production lines, draw up the
installation design of the machine.
The design must include all the operating conditions in order to comply with the standards in force on
safety at work place.
Check that the installation space is properly ventilated in order to avoid air concentration unhealthy for
the operators.
Apply the most suitable solutions for reducing the noise levels and the acoustic pollution to minimum.
Carry out the electrical connections professionally and in full compliance with the instructions provided
by the manufacturer and the specific regulations in force.
English
To Next Page
Loading...
