Robopac SPIROR HP - Modification Mode Regarding the Settings

SPIROR HP - DR
1) Rotation of the reel change / wheel.
2) Incoming product pressure unit
ascent/descent.
3) Outgoing product pressure unit
ascent/descent.
4) The product infeed/outfeed pulling unit
forward/backward.
5) Clamping unit exit/retraction.
6) Upward/downward of the welder/rubber
on the stopper.
7) Exit/return rotating cut-off.
8) Cutting blade forward/backward travel.
9) Opening/closing of the product entrance
guide.
10) Opening/closing of the product exit
guide.
By touching the image of the object you
want to move, you will enable the keys
corresponding to the possible
movement.
For example, by touching the image of
the wheel (B) it will be displayed the key
(C) (blue, therefore enabled).
(C) key (if present) moves the wheel.
(C) key (impulse key) moves the wheel
for "reel change".
6.4. MODIFICATION MODE REGARDING THE SETTINGS
‒ Written editings and values.
‒ Progressive regulation of values.
|
Important
T
he performed modifications become instantly operative and stored automatically.
English
63/95