Robopac SPIROR HP - Page 3

SPIROR HP - DR
5. INFORMATION ON ADJUSTMENTS
5.1. RECOMMENDATIONS FOR ADJUSTMENTS
5.2. PRESSURE PLATEN PRESSURE ADJUSTMENT
5.3. FILM WRAPPING TENSION - ADJUSTMENT
5.4. GUIDE UNITS ADJUSTMENT
5.4.1. PNEUMATIC GUIDES ON ONE SIDE
5.4.2. MANUAL SELF-CENTRING GUIDES
6. ABOUT THE USE
6.1. RECOMMENDATIONS FOR OPERATION AND USE
6.2. CONTROL DESCRIPTION
6.3. DISPLAY IN OPERATION
6.3.1. USING THE PANEL
6.3.2. MAIN PAGE
6.3.3. OPERATOR AND PASSWORD CHANGE KEY
6.3.4. DEFAULT PASSWORD RESET
6.3.5. GENERAL PARAMETERS SETTINGS
6.3.6. SOFTWARE SETTINGS AND DISPLAYS
6.3.7. DATE AND TIME SETTING
6.3.8. DESCRIPTION OF CONTROL PANEL MANUAL CONTROLS
6.4. MODIFICATION MODE REGARDING THE SETTINGS
6.4.1. WRITTEN EDITINGS AND VALUES
6.4.2. PROGRESSIVE REGULATION OF VALUES
6.4.3. “COPY RECIPES” FUNCTION
6.5. CYCLE PARAMETER SETTING (RECIPE COMPOSITION)
6.6. WRAPPING CYCLE RESET
6.7. MACHINE CONDITIONS
6.7.1. MACHINE ISOLATED FROM THE POWER SUPPLIES
6.7.2. MACHINE ON
6.7.3. MACHINE READY FOR THE CYCLE
6.8. MACHINE OPERATION PREPARATION
6.9. MACHINE STARTING
6.9.1. PUTTING THE ROTATING RING IN PHASE
6.9.2. FILM SPOOL LOADING
6.9.3. INSERT THE FILM IN THE CLAMP
6.10. CYCLE START
6.11. TYPES OF STOPPING AND STARTING
6.11.1. TEMPORARY STOP (VOLUNTARY)
6.11.2. ELECTRIC BLACK-OUT STOP
6.11.3. PRODUCTION END STOP
6.11.4. EMERGENCY STOP
7. MAINTENANCE INFORMATION
7.1. MAINTENANCE INSTRUCTIONS
7.2. ROUTINE MAINTENANCE INTERVALS
7.3. LUBRICATION POINT DIAGRAM
7.4. LUBRICANTS TABLE
7.5. DRAINING THE CONDENSATE
7.6. CLEANING THE FILTER
7.7. ROTATING RING BELT - ADJUSTMENT
7.8. PRODUCT INFEED UNIT CHAIN - ADJUSTMENT
7.9. MACHINE CLEANING
8. TROUBLESHOOTING
8.1. SOME SUGGESTIONS ON OPERATION
English
3/95