SPIROR HP - DR
Phase 2
‒ Infeed/outfeed conveyors starts.
‒ The product moves forward and engages
photocell (B2).
‒ The outfeed pressure platen lowers on
the product.
Phase 3
‒ The "central bands" timer starts
counting; at count completed, the
conveyor stops, the rotating ring starts
and counts the "reinforcing revolutions"
set; the product is wrapped for the
number of reinforcing revolutions set.
Note
The number of central bands is
determined by the "Central bands" timer,
the speed of the carriers and the length
of the product.
English
To Next Page
Loading...
