Rockwell Automation Publication 20P-TG002B-EN-P - February 2018 81
Part Replacement Procedures Chapter 3
4. Remove the bolts, washers and wiring from the power terminals (U, V,
W, C , and D ) .
5. Remove the protective covers from the drive (see page 43
).
6. Remove the pulse transformer and switching power supply boards from
the drive (see page 62
). You do not need to remove the switching power
supply board from the back of the pulse transformer board for this
procedure.
3
3
U Phase V Phase
4
Bottom View of Drive
W Phase
D
C
IMPORTANT Mark all connections and wires before removal to avoid incorrect
wiring during reassembly.
To Next Page
Loading...
Need help?
General
