116 Rockwell Automation Publication 1426-UM001J-EN-P - August 2019
Chapter 6 Logging
The Data, Energy, Waveform, and Trigger Data logs support sequential record
retrieval but require additional configuration steps. See Energy Log
on page 134,
Wave f o r m L o g (M 6 a n d M8 m o d e l )
on page 118, Data Log on page 138, and
Trigger Data Log (M6 and M8 model)
on page 176 for more information.
To initiate this type of log retrieval, a controller or application sets parameter
values in the Configuration.Log_Read
table, writes the table to the power
monitor, and then reads the applicable LoggingResults table.
See the Communication
chapter for more information.
Selected Log
Selects the log from which to retrieve information. Once a request has been
made, the auto, or sequential, return feature brings back successive records each
time the log is read. Some logs support individual record requests. In the Data,
Energy, Waveform, and Trigger Logs, the data that are returned are file names of
the log files.
Requests not supported by the power monitor model are ignored.
IMPORTANT Sequential record retrieval is available for networks such as DeviceNet® that
do not support FTP. Download speed and performance by using sequential
record retrieval is lower than if using FTP.
Parameter Value Results Table
1 = Event Log LoggingResults.Event_Log (sequential only)
2 = Min/Max Log LoggingResults.MIN_MAX.Log
3 = Load Factor Log LoggingResults.LoadFactor.Log
4 = Time of Use Log LoggingResults.TOU.Log
5 = Setpoint Log LoggingResults.Setpoint_Log (sequential only)
6 = Alarm Log LoggingResults.Alarm_Log
(sequential only)
7 = Data Log File List LoggingResults.DataLog_FileName
8 = Energy Log File List LoggingResults.EnergyLog_FileName
9 = Metering Snapshot File LoggingResults.Snapshot_Log (M6 and M8 model)
10 = Power Quality Log LoggingResults.Power_Quality_Log (M6 and M8 model)
11 = Waveform Log File LoggingResults.WaveformFileName (M6 and M8 model)
12 = Trigger Data File LoggingResults.TriggerData_Log (M6 and M8 model)
13 = Trigger Header File LoggingResults.TriggerData_Header (M6 and M8 model)
14 = EN50160 Weekly Log LoggingResults.EN50160_Weekly_Log (M8 only)
15 = EN50160 Yearly Log LoggingResults.EN50160_Yearly_Log (M8 only)
To Next Page
Loading...
