Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
322User Manual 1173.9240.02 ─ 17
11.8.2 Defining Limit Checks
Note that in remote control, upper and lower limit lines are configured using separate
commands. Thus, you must decide in advance which you want to configure. The x-val-
ues for both upper and lower limit lines are defined as a common control line. This con-
trol line is the reference for the y-values for both upper and lower limit lines.
● Configuring Limit Lines..........................................................................................322
● Managing Limit Lines............................................................................................ 329
● Checking the Results of a Limit Check................................................................. 331
● Programming Example: Using Limit Lines............................................................ 332
11.8.2.1 Configuring Limit Lines
CALCulate:LIMit:COMMent.............................................................................................322
CALCulate:LIMit<k>:CONTrol[:DATA].............................................................................. 323
CALCulate:LIMit<k>:CONTrol:DOMain.............................................................................323
CALCulate:LIMit<k>:CONTrol:MODE...............................................................................323
CALCulate:LIMit<k>:CONTrol:OFFSet............................................................................. 323
CALCulate:LIMit<k>:CONTrol:SHIFt................................................................................ 324
CALCulate:LIMit<k>:CONTrol:SPACing............................................................................324
CALCulate:LIMit<k>:LOWer[:DATA].................................................................................324
CALCulate:LIMit<k>:LOWer:MARGin...............................................................................325
CALCulate:LIMit<k>:LOWer:MODE................................................................................. 325
CALCulate:LIMit<k>:LOWer:OFFSet................................................................................325
CALCulate:LIMit<k>:LOWer:SHIFt...................................................................................325
CALCulate:LIMit<k>:LOWer:SPACing.............................................................................. 326
CALCulate:LIMit<k>:LOWer:STATe................................................................................. 326
CALCulate:LIMit<k>:LOWer:THReshold...........................................................................326
CALCulate:LIMit<k>:NAME.............................................................................................326
CALCulate:LIMit<k>:UNIT...............................................................................................327
CALCulate:LIMit<k>:UPPer[:DATA]................................................................................. 327
CALCulate:LIMit<k>:UPPer:MARGin................................................................................327
CALCulate:LIMit<k>:UPPer:MODE.................................................................................. 327
CALCulate:LIMit<k>:UPPer:OFFSet.................................................................................328
CALCulate:LIMit<k>:UPPer:SHIFt....................................................................................328
CALCulate:LIMit<k>:UPPer:SPACing...............................................................................328
CALCulate:LIMit<k>:UPPer:STATe..................................................................................329
CALCulate:LIMit<k>:UPPer:THReshold............................................................................329
CALCulate:LIMit:COMMent <Comment>
This command defines a comment for a limit line.
Parameters:
<Comment> String containing the description of the limit line. The comment
may have up to 40 characters.
Manual operation: See "Comment" on page 151
Analyzing Results
To Next Page
Loading...
