R&S PR100 User Manual
MEMory
. :EXCHange <mem_loc1>, <mem_loc2>
Exchange of contents of two memory locations. The contents of location
<mem_loc1> is swapped with that of location <mem_loc2>. In case one of the
locations is RX, and RX would get an impossible value due to the exchange,
the RX value remains unchanged, and the other location gets RX’s value. The
impossible value is thus lost.
Parameters:
<mem_loc1> CURRENT|0...1023|RX
<mem_loc2> CURRENT|0...1023|RX
Example:
MEMory:EXCHange 123, RX
MEMory
. :LABel <mem_loc>, <String>
Defines a descriptive text for a memory location
Parameters:
<mem_loc> 0...1023
Example:
MEMory:LABel 500, “Radio FM”
MEMory
. :LABel? <mem_loc>
Query of the descriptive label of a memory location
Parameter:
<mem_loc> 0...1023
Result:
String
Example:
MEMory:LABel? 500 -> “Radio FM”
11.10.1 Memory list subsystem
The commands listed in this section are only intended for testing the
associated function in the user interface. They are not to be used by the
remote user.
Although each memory location (0...1023) can be addressed directly, it is
sometimes convenient to run through all of them in a specific order (e.g. in
To Next Page
Loading...
