R&S PR100 User Manual
Bit
No.
Meaning
1 Running up
This bit is set if sweeping is to be carried out in the direction of
increasing frequency values or memory location numbers.
2 Running down
This bit is set if sweeping is to be carried out in the direction of
decreasing frequency values or memory location numbers.
3 FSCAN active
This bit is set if FREQ:MODE is set to SWEep
4 MSCAN active
This bit is set if FREQ:MODE is set to MSCan
5 not used, always 0 (was used for DSCAN mode in EB200)
6 not used, always 0 (was used for FASTlevcw mode in EB200)
7 not used, always 0 (was used for LIST mode in EB200)
8 PSCAN active
This bit is set if FREQ:MODE is set to PSCan
9.2.1.6 STATus:TRACe register
This register contains information on ambiguous states of the traces
MTRACE, ITRACE, IFPAN, SSTART and SSTOP. It can be queried with the
commands STATus:TRACe:CONDition? or STATus:TRACe[:EVENt]?.
To Next Page
Loading...
