R&S PR100 User Manual
MEMory
. :LIST
. . :MEMory? <mem_loc>
Find the memory-list item that links to <mem_loc>
Parameter:
<mem_loc> 0...1023
Result:
integer number in the range [0,1023]
NONE No memory-list item link to <mem_loc>
Example:
MEMory:LIST:MEMory? 60 -> 25
MEMory
. :LIST
. . :SORT <order>
Sorts the memory locations and puts the result in the memory list.
Parameters:
<order> One of the following:
MEM_UP increasing memory-location number
MEM_DOWN decreasing memory-location number
FREQ_UP increasing frequency
FREQ_DOWN descreasing frequency
DES_UP increasing alphabetical on description
DES_DOWN decreasing alphabetical on description
Example:
MEMory:LIST:SORT DES_DOWN
11.10.2 Memory save subsystem
This subsystem contains all commands for automatically saving receiver
settings to memory locations.
MEMory
. :SAVE
. . :AUTO
. . . :STARt <mem_loc>
Sets first memory location that is used to save receiver settings when
automatic save is active. The last location is set with
MEM:SAVE:AUTO:STOP. A start location that is larger than the stop location
is rejected with error -221(“Settings conflict”).
This setting applies to scans with squelch on (see OUTP:SQU:STOR). When
the received signal is stronger than the squelch level during a memory scan or
a frequency scan, the receiver settings are saved into the first free auto-save
memory-location (see MEM:SAVE:AUTO:STAR and
To Next Page
Loading...
