R&S PR100 User Manual
6.5 Inserting the battery
The R&S PR100 is fitted with a lithium ion battery.
The HA-Z206 battery pack has a charging capacity of 6.75 Ah.
The battery is inserted into the bottom right of the instrument.
The cover must first be pulled downwards to unlock it and then folded upwards to
open it.
The battery is NOT fitted in the R&S PR100 on delivery and must therefore be fitted
before the device can be used for the first time.
6.6 Connecting to the power supply
The R&S PR100 can be powered using the mains power adaptor or the internal
battery supplied. When fully charged, the built-in lithium ion battery permits approx.
3.5 hours of operation. When the R&S PR100 is delivered, the battery may be
completely discharged. Should you wish to use it without a mains power connection
you will therefore need to charge it. Charging time is approx. 3.5 hours with the
device switched off. During operation using mains power, the R&S PR100
simultaneously charges the internal battery. Insert the power adaptor plug into the
POWER ADAPTOR socket on the left-hand side of the device until it clicks into
place. Then connect the adaptor to the mains power socket.
The adapter voltage range is 100 V to 240 V AC / 50 Hz to 60 Hz.
The PR100's DC supply range is +15 V DC +/-10%, max. 2 A
To Next Page
Loading...
