R&S PR100 User Manual
Insert the adaptor plug into the POWER ADAPTER socket on the left side of the
instrument until it locks into place. Then connect the adaptor to the mains power
supply.
The adaptor voltage range is 100 V to 240 V / 50 Hz to 60 Hz.
The device's DC supply range is +15 V DC +/-10%, max. 2 A
To charge the battery externally, place it in the external R&S HA-Z203 battery
charger and charge it using the plug-in power adaptor.
The plug-in power adaptor is the same R&S HA-Z201 adaptor used for the receiver
itself.
6.8 Switching on the monitoring receiver
To switch on the R&S PR100, press the grey button at the bottom left of the
front panel.
When the R&S PR100 is switched on, the settings in use when it was last switched
off are loaded.
Should you wish to start the R&S PR100 with factory settings, the LOCK key should
be pressed and held for approx. 5 seconds when you switch the unit on.
To Next Page
Loading...
