R&S PR100 User Manual
11.10 MEMory subsystem
This subsystem contains all the functions necessary to operate the device’s
memory locations. A Memory location can be addressed in the following ways:
CURRENT the currently selected memory location
0 ... 1023 memory location 0 to memory location 1023
NEXT the next free memory location, starting from and including
the current location
RX the current receiver settings
Not all of these addressing options are allowed for every memory command.
Those that are allowed are specified. Note that the currently active memory
location can be queried by the “MSCAN:CHAN?” command.
MEMory
. :CLEar <mem_loc> [,<count>|MAXimum]
Clearing the contents of a single memory location or a range of memory
locations.
Parameters:
<mem_loc> CURRENT|0...1023
<count> number of memory locations to be cleared, starting from
memory location <mem_loc>
As a default value, <count> = 1.
MAXimum clearing all memory locations following and including
<mem_loc>
Example:
MEMory:CLEar 123
To Next Page
Loading...
