R&S PR100 User Manual
Figure 5 shows the payload of a PSCAN UDP package where the trace
selector flags “LEVEL”, “FREQ_LOW”, “FREQ_HIGH”, and
“OPTIONAL_HEADER” are set.
A PSCAN cycle is a single scan from start till the stop frequency.
The last sample of a cycle will be the “end marker” value.
A single PSCAN cycle consist of 1 or more PSCAN UDP packges.
Figure 5 Payload PSCAN UDP Package
Note
The PSCAN stream is available during a running PSCAN only.
• To enable a PSCAN stream including LEVEL, FREQ_LOW and
FREQ_HIGH:
If stream client is 172.17.75.50:19000 :
Trace:Udp:Tag:On "172.17.75.50", 19000, PSCAN
Trace:udp:flag:on "172.17.75.1", 19000, "FREQ:LOW:rx",
"FREQ:HIGH:rx", "VOLT:AC"
• To get an overview of all UDP streams:
Trace:udp?
• To delete all UDP streams:
trace:Udp:Delete ALL
13 Default Values
CALCulation subsystem
Description Command [CALC:] Factory
Default
Min Max Unit *RST PWR
ON
IFPAN Average type IFP:AVER:TYPE MAX NA NA enum + -
PSCAN Average type PSC:AVER:TYPE MAX NA NA enum + -
13.1 DISPlay subsystem
Item Command [DISP:] Factory
Default
Min Max Unit *RST PWR
ON
Display auto off AUTO:OFF ? bool + -
Brightness BRIG 0.5 0.01 1.0 steps + -
Switch on time backlight BRIG:DWEL 0 s + -
Color map CMAP IND enum + -
Date format DATE:FORM DDMM date - -
Display disable DIS 0 bool + -
Display enable ENAB 1 bool + -
Display frequency information FREQ:OFFS SYMB - + -
Dispay fieldstrength information FSTR 0 bool + -
IFPAN level range IFP:LEV:RANG 60.0 10.0 140.0 steps + -
IFPAN signal level max IFP:LEV:REF 50.0 -30.0 110.0 dBµV + -
Level bar lower limit LEV:LIM:MIN -10.0 -30.0 110.0 dBµV + -
Level bar range LEV:RANG 60.0 30.0 90.0 dB + -
PSCAN signal level range PSC:LEV:RANG 60.0 10.0 140.0 dB + -
PSCAN signal level max PSC:LEV:REF 50.0 -30.0 110.0 dBµV + -
To Next Page
Loading...
