R&S PR100 User Manual
PARALLEL-POLL REGISTER ENABLE sets parallel poll enable register to
the value indicated. Query *PRE? returns the contents of the parallel poll
enable register in decimal form.
*RST
RESET sets the device to a defined default status. The default setting is
indicated in the description of the commands.
*SRE 0 ... 255
SERVICE REQUEST ENABLE sets the service request enable register to the
value indicated. Bit 6 (MSS mask bit) remains 0. This command determines
under which conditions a service request is triggered. Query *SRE? reads the
contents of the service request enable register in decimal form. Bit 6 is always
0.
*STB?
READ STATUS BYTE QUERY reads out the contents of the status byte in
decimal form.
*TRG
TRIGGER triggers the same actions as the INITiate:CONM[:IMMediate]
command.
*TST?
SELFTEST QUERY triggers the module state test and yields a figure which is
to be interpreted as the bit field:
Result = 0
All modules are ok.
Result b 0
There is a fault in one or several modules. The information about the
possible error can be queried by means of the SYSTem:ERRor?
Command.
*WAI
WAIT-to-CONTINUE only permits the servicing of the subsequent commands
after all preceding commands have been executed and all signals have
settled.
10 Instrument Behaviour
The behaviour of the Orion MR is defined by the following aspects:
• Error Situations
There are several types of error situations that apply to a number of,
otherwise unrelated, commands
• Ranging and Rouding
This applies to all commands that set a value. Ideally, the user supplies
a value that is within the instrument’s range and corresponds with its
resolution. When this ideal situation is not met, ranging and rounding
must be applied to get a value the instrument can handle.
To Next Page
Loading...
