R&S PR100 User Manual
[SENSe]
. :FUNCtion
. . :OFF
. . . :COUNt?
Query of the number of sensor functions being inactive.
Parameters:
none
Result:
Number of sensor functions being inactive
Example:
FUNCtion:OFF:COUNt? -> 2
[SENSe]
. :FUNCtion
. . [:ON] <sensor_function> {,<sensor_function>}
Switch on of one or several sensor functions.
Parameters:
<sensor_function> is one of the following strings:
"VOLTage:AC" switch on level measurement
"FREQuency:OFFSet" switch on offset measurement
"FSTRength" switch on field strength measurement
Remark:
If any of the sensor functions is changed, the trace data set MTRACE is
always deleted.
Error message:
If CONCurrent = OFF, an error -108, "Parameter not allowed" will be
generated for two or several parameters.
*RST state:
"VOLTage:AC"
Example:
FUNCtion "VOLT:AC", "FREQ:OFFS"
[SENSe]
. :FUNCtion
. . [:ON]?
Query of sensor functions being switched on.
To Next Page
Loading...
