R&S PR100 User Manual
without a mains switch are integrated into racks or systems, a disconnecting device
must be provided at the system level.
10. Never use the product if the power cable is damaged. Take appropriate safety
measures and carefully lay the power cable to ensure that the latter cannot be
damaged and that no one can be hurt, for example by tripping over the cable or
receiving an electric shock.
11. The product may be operated only from TN/TT mains power networks with a
maximum 16A fuse.
12. Do not insert the plug into sockets that are dusty or dirty. Insert the plug firmly
and all the way into the socket, otherwise there is a risk of sparks, fire and/or injury.
13. Do not overload any sockets, extension cables or connector strips; doing so may
cause fire or electric shocks.
14. For circuit measurements with Vrms voltages above 30V, suitable measures (e.g.
appropriate measuring equipment, fuses, current limiting, electrical separation,
insulation, etc.) should be taken to avoid any hazards.
15. Ensure that any connections with computer equipment comply with
IEC950/EN60950.
16. Never remove the cover or part of the housing while you are operating the
product. This will expose circuits and components and may cause injury, fire or
damage to the product.
17. If a product is to be permanently installed, the earth/ground connection on site
and the product's earth/ground conductor must be connected before any other
connection is made. The product must only be installed and connected by a
specialist electrician.
18. For permanently installed equipment without built-in fuses, circuit breakers or
similar protective devices, the mains circuit must be fuse-protected in such a way that
users and products are sufficiently protected.
19. Do not insert any objects which are not designed for this purpose into the
openings on the housing. Never pour any liquids onto or into the housing. This may
cause a short circuit inside the product and/or electric shocks, fire or injury.
20. Take appropriate measures to protect against excess voltage caused by adverse
weather conditions (e.g. thunderstorms) reaching the product, otherwise, operating
personnel will be exposed to the risk of electric shocks.
21. R&S products are not protected against water penetration unless otherwise
specified (see Point 1). If this is not observed there is a risk of electric shocks or
damage to the product, which may also result in personal injury.
22. Never use the product in conditions where condensation has formed or may form
in or on the product, for example when the product is moved from a cold to a warm
environment.
23. Do not obstruct any slots or openings on the product, since these are necessary
for ventilation and prevent the product from overheating. Do not place the product on
To Next Page
Loading...
