Chapter 5 Operating
2104.6536.72 - 5.10 - E-1
ID Operation (which authorizes you to make settings that directly affect transmitter opera-
tion).
Note You can change, create or delete user profiles with the aid of the user administration facility,
which you call up via the web browser (see section "User Administration").
From the Change User context menu, you can log on in any menu under a different user
ID. No password is required to change the user ID under local control (according to the fac-
tory default). You can also protect access to the display by entering a password.
Fig. 11 Changing user at display in local operation mode
You can select a user profile by clicking Select user from list.
The following factory-default user profiles are available for local operation:
Note In the event of a power failure, the instrument resets to the Operation authorization level.
Changing user at display without entering a password
In the following example a user profile "Schmidt" has been set up in user administration.
The user has obtained authorization for local operation.
1. From the context menu, call the Change User command.
2. Use Select user from list to select the required user, e.g. Configuration, and confirm
your choice with OK.
User profile Description Password
a)
a) By default the password (factory setting 1234) is needed only for browser-based operation. Every user can
change his/her own password via the user administration program.
Configuration Authorization to set basic transmitter parameters, e.g.
Setup
Maintenance Authorization to perform maintenance tasks, e.g. soft-
ware updates
Operation Authorization to make settings that directly affect
transmitter operation
Query Read-only authorization
Config-Engl Authorization to set basic transmitter parameters, e.g.
setup; this ID also changes the menu language to
English (irrespective of the preset language, e.g. Chi-
nese)
To Next Page
Loading...
