Chapter 5 Operating
2104.6536.72 - 5.11 - E-1
You are then locked on again with the rights of your chosen user. The Logon menu is auto-
matically closed after a short while and the display once again shows the menu that was
open before the change of user.
Change of user via the display by entering a password (example)
In the following example a user profile "Schmidt" has been set up in user administration.
The user has obtained authorization for local control, but must enter a password.
1. From the context menu, call the Change User command.
2. Go to Select user from list and select the user Schmidt <pw>.
The "<pw>" in angle brackets tells you that a password is needed.
3. Select the Type password command.
To Next Page
Loading...
