2
21
How to Edit
How to read the parameter list
MEMO
In addition to these two modes, there is another, the Advanced Edit mode, for making more detailed
settings for the EQ and COMP.
MEMO
“Edit” refers to the process of changing parameter values.
To modify parameter values you must be in the Edit mode. The names of all the parameters you can
modify are in the Parameter List printed on the front panel.
The parameter list has four indicators arranged horizontally and seven indicators arranged vertically.
In the Edit mode, one of the horizontal indicators and one of the vertical indicators will always be lit.
This shows which parameter is being edited; i.e., the intersection of the indicated column and row is
the currently selected parameter. The display shows the value of this parameter. To edit a particular
parameter, refer to the parameter list and use the [SELECT] and [ ] [ ] buttons to select it.
Selected Parameter
Value (ashing)
The intersection of the
indicated column and row
can be set
to each pad
can be set to
each Patch
can be set to
the entire system
DECAY PAD1
0