2
27
How to Edit Sound Parameters
Pressing PATCH/VALUE [+] while holding down PATCH/VALUE [-] (or vice versa) makes this change more
rapidly. However, when selecting a Parameter Group Instrument (INST), when youpress PATCH/VALUE [+]
while holding down PATCH/VALUE [-] (or vice versa), you jump to the next Instrument group.
In the Play mode, use the PATCH/VALUE [-] or [+] buttons to select the
Patch (1–99) to edit.
1
Press [EDIT] to enter the Edit mode.
2
Strike the pad you wish to edit.
3
Turn Layer on or off if necessary.
4
Press [BANK A/B] to select the bank you wish to edit.
The selected PAD BANK indicator will be ashing.
5
Press [SOUND] or [SELECT] to select the SOUND parameter group.
6
Press [ ] or [ ] to select the parameter to be edited.
7
Use PATCH/VALUE [-] or [+] to set the value.
For a numerical parameter, pressing PATCH/VALUE [-] will decrease the value, and
pressing PATCH/VALUE [+] will increase the value.
8
MEMO
Selecting and changing parameters is called editing.
MEMO
You can have only one of the Pad Bank Instruments sound by setting Layer to OFF.
MEMO
Editing a sound parameter
To switch between the two pad banks, and edit each bank separately. It is not possible to
simultaneously edit the sound parameters of pad banks A and B. Use [BANK A/B]
To Next Page
Loading...
Need help?
General
