2
35
Adjusting the Pad Sensitivity (TRIG SENS)
1
2
5
3
Press [EDIT] to enter the Edit mode.
Use [ ] or [ ] to select TRIG SENS.
Press [SYSTEM] or [SELECT] to select the SYSTEM parameter group.
Strike one of the 8 pads to check the result.
When you strike the pad, the strength with which the pad is struck (velocity) is shown in the display. The
Velocity value indicates the level you struck the pad. From soft to hard, 1 – 127.
MEMO
NOTE
By adjusting the TRIG SENS in the SYSTEM parameter group you can adjust the sensitivity of the pad
when it is struck (the range of adjustment is 1–16). Higher settings result in higher sensitivity, so that the
pad will produce a loud volume even when struck softly. This parameter applies to all 8 pads.
Factory Trigger Sensitivity (TRIG SENS) settings for the internal pad reect the average user´s pref erences. If
these settings produce good results for you, then there is no need to change the Trigger Sensitivity values.
This parameter is set for all 8 pads, i.e., the same value applies to all pads. However, this parameter can be set
independently for each connected external pad. Trigger Sensitivity (TRIG SENS) settings are common to all
patches.
MEMO
TRIG-SENS
VEL:000 8
TRIG-SENS
VEL:089 8
4
Use PATCH/VALUE [-] or [+] to set the value.
To Next Page
Loading...
Need help?
General
