Roland Octapad SPD-20X - How to Save a Single Patch

64
How to Save a Single Patch
If you wish to save the current patch to SD card, see the following procedures.
1
Press [EDIT] to enter the Edit mode.
2
Press [SELECT] or [SYETEM] to select SD CARD.
3
Use [-] or [+] to select SAVE. Then press [ALL/ENTER]
Save:Name
[BACKUP ]
4
Use [ ] or [ ] to select which character you wish to edit and then use
PATCH/VALUE [-] or [+] to adjust the name for the backup file on SD card.
Press [All/ENTER] to confirm.
The input character table in SPD-20X:
This name is not the Patch Name. It is the Save Name you will see when LOAD or DELETE a patch from
SD card. This name will be saved on SD card and won’t be loaded to the patch.
NOTE
MEMO
A–Z a–z 0–9 ! * # & ' ( )
[ ] * + , - . / : ?
_ < = > @ | } ^ ¥ `
$ % ; { Blank
Save:Dest
01:============
5
Use PATCH/VALUE [-] or [+] to choose the destination. And press [ALL/
ENTER] to confirm.
The number on the left side is the Destination Slot Number on SD card. The name on the right side
is the Destination Save Name. The above screenshot shows the destination slot is empty. If this slot is
occupied, it will show the Save Name you previously set when saving. There are 99 storage slots on SD
card, and you can save to any position as you like. To move quickly through 99 patch numbers, press [-]
while holding [+] to forward quickly, or vice versa.
MEMO
S a v e :OverWrite
Sure? Yes
6
If the destination slot is already occupied, the following screen will be
shown.
7
Use PATCH/VALUE [-] or [+] to toggle between ‘Yes’ and ‘No’, press [ALL/
ENTER] to confirm.