Roland RD-2000 Parameter Guide

Detailed Settings for Each Function
Saving System Settings
Changes you make to the system settings are temporary, and will
be lost when you turn o the power.
If you want to keep your changes, you must save the system
settings.
1. In the SYSTEM EDIT screen, press the [WRITE]
button.
A conrmation message appears.
2. Press the [MENU] button.
The system settings are saved in the system memory of the RD-
2000.
If you decide to cancel, press the [EXIT] button.
Parameters saved in SYSTEM (System parameter)
5 SYSTEM
5 USB AUDIO
5 PART SW
5 COMPRESSOR
USB Audio Settings
Here you can make input/output settings for USB audio.
[MENU] button
0
Select “System”
0
[ENTER] button
0
“USB
AUDIO” tab
Parameter Value Explanation
USB Audio
Input Switch
OFF, ON
Species whether to enable
USB-AUDIO from an external
device.
USB Audio
Input Volume
0–127
Species the USB audio signal
level from an external device.
USB Audio
Output
Switch
OFF, ON
Species whether USB audio is
output to an external device.
Parameter Value Explanation
USB Audio
Output
Volume
0–127
Species the USB audio signal
level to an external device.
USB Audio
Output
Assign
MAIN, SUB
Species whether the USB
audio signal is output from the
MAIN jacks or from the SUB
jacks.
USB Audio In/
Out Select
IN, OUT
Selects the USB audio signal
that is indicated and adjusted
by the slider.
Parameter Value Explanation
Output Mix/
Parallel
MIX, PARALLEL
Outputting the SUB OUT Output from MAIN OUT (Output Mix/Parallel)
This setting species whether the output of zones assigned to be output from SUB OUT is sent from
MAIN OUT (Mix) or from SUB OUT (Parallel).
LCD Brightness 1–10
Adjusting the Brightness of the Display (LCD Brightness)
You can adjust the brightness of the RD-2000’s display.
Auto O
OFF,
30 [min],
240 [min]
(default)
Making the Power Automatically Turn O After a Time (Auto O)
With the factory settings, the RD-2000 will automatically be switched o 4 hours after you stop playing
or operating the unit.
If you don’t need the unit to turn o automatically, set “Auto O” to the “OFF” setting.
* When turning the unit back on after it has been shut down due to the Auto O function, always make
sure to allow at least ten seconds to pass after the unit has been shut o before you turn the unit back
on. If you turn it back on too rapidly, the Auto O function will not have had enough time to reset
itself, and you may not be able to turn on the unit in the normal way.
26

Roland RD-2000 Specifications

General

Pedal jack	Yes
Sound effects	Compression, Equalization, Modulation, Reverberation
Tones quantity	1100
Built-in speaker(s)	No
Number of front panel sliders	9
Reverberation effects quantity	6
Preset programs quantity	300
Keyboard name	PHA-50
Keys quantity	88 keys
Display resolution	256 x 80 pixels
Power consumption (max)	23 W
Audio (L/R) out	2
Headphone outputs	1
USB connector type	USB Type-A, USB Type-B
Headphone connectivity	6.3 mm
Product color	Black
Cables included	AC

Weight and Dimensions

Depth	367 mm
Width	1412 mm
Height	140 mm
Weight	21700 g