Roland RD-2000 Parameter Guide

56
Modulation FX Parameters
Parameter Value Explanation
Feedback
Knob
OFF,
OVERDRIVE DRIVE,
OVERDRIVE PAN,
DELAY FEEDBACK,
DELAY BALANCE
Species the parameter
that is controlled by the
MODULATION FX [FEEDBACK]
knob.
Overdrive
Drive #
0–127
Degree of distortion
Also changes the volume.
Overdrive
Pan #
L64–63R
Stereo location of the
overdrive sound
Delay Time
(sync sw)
OFF, ON
If this is ON, the modulation
is synchronized to the tempo
of the rhythm (owner’s
manual: p. 24).
Delay Time
(msec)/
Delay Time
(note)
1–2600 [msec]
Adjusts the delay time from
the direct sound until the
delay sound is heard.
note (p. 60)
Delay
Feedback #
-98–+98 [%]
Adjusts the proportion of the
delay sound that is fed back
into the eect. Negative “-”
settings will invert the phase.
Delay HF
Damp
200–8000 [Hz],
BYPASS
Adjusts the frequency
above which sound fed
back to the eect will be cut
(BYPASS: no cut).
Delay
Balance #
D100:0W–
D0:100W
Adjusts the volume balance
between the sound that is
sent through the delay (W)
and the sound that is not
sent through the delay (D).
Level 0–127 Output Level
52: DS
0
CHORUS
The parameters are essentially the same as in “49: OD
0
CHORUS,”
with the exception of the following two.
5 Overdrive Drive
0
Distortion Drive
5 Overdrive Pan
0
Distortion Pan
L in
R in
Chorus
Distortion
L out
R out
Balance W
Balance W
Balance D
Balance D
53: DS
0
FLANGER
The parameters are essentially the same as in “50: OD
0
FLANGER,” with the exception of the following two.
5 Overdrive Drive
0
Distortion Drive
5 Overdrive Pan
0
Distortion Pan
L in
R in
Flanger
Distortion
L out
R out
Balance W
Balance W
Balance D
Balance D
Feedback
54: DS
0
DELAY
The parameters are essentially the same as in “51: OD
0
DELAY,”
with the exception of the following two.
5 Overdrive Drive
0
Distortion Drive
5 Overdrive Pan
0
Distortion Pan
L in
R in
Delay
Distortion
L out
R out
Balance W
Balance W
Balance D
Balance D
Feedback
55: OD/DS
0
TWAH
Amp
Simulator
2-Band
EQ
L in
R in
Overdrive/
Distortion
L out
R out
Touch
Wah
Parameter Value Explanation
Switch OFF, ON Turns the eect on/o.
Depth Knob
DRIVE,
TONE,
TWAH SENS,
TWAH MANUAL,
TWAH PEAK,
TWAH BALANCE
Species the parameter
that is controlled by the
MODULATION FX [DEPTH]
knob.
Rate Knob
Species the parameter
that is controlled by the
MODULATION FX [RATE]
knob.
Feedback
Knob
OFF,
DRIVE,
TONE,
TWAH SENS,
TWAH MANUAL,
TWAH PEAK,
TWAH BALANCE
Species the parameter
that is controlled by the
MODULATION FX [FEEDBACK]
knob.
Drive Switch OFF, ON
Turns overdrive/distortion
on/o
Drive Type
OVERDRIVE,
DISTORTION
Type of distortion
Drive # 0–127
Degree of distortion
Also changes the volume.
Tone # 0–127
Sound quality of the
Overdrive eect
Amp Switch OFF, ON
Turns the Amp Simulator on/
o.
Amp Type
SMALL,
BUILT-IN,
2-STACK,
3-STACK
Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type
amp
2-STACK: large double stack
amp
3-STACK: large triple stack
amp
TWah Switch OFF, ON Wah on/o
TWah Filter
Type
LPF, BPF
Type of lter
LPF: Produces a wah eect in
a broad frequency range.
BPF: Produces a wah eect in
a narrow frequency range.

Roland RD-2000 Specifications

General

Pedal jack	Yes
Sound effects	Compression, Equalization, Modulation, Reverberation
Tones quantity	1100
Built-in speaker(s)	No
Number of front panel sliders	9
Reverberation effects quantity	6
Preset programs quantity	300
Keyboard name	PHA-50
Keys quantity	88 keys
Display resolution	256 x 80 pixels
Power consumption (max)	23 W
Audio (L/R) out	2
Headphone outputs	1
USB connector type	USB Type-A, USB Type-B
Headphone connectivity	6.3 mm
Product color	Black
Cables included	AC

Weight and Dimensions

Depth	367 mm
Width	1412 mm
Height	140 mm
Weight	21700 g